|
|
INSTRUCTIONS FOR MARINE EXTERIOR
SALT REMOVAL
EXTERIOR WASH
For removing salt from boats, trailers, trailer brakes, jetskis, wet suits, towing vehicles and other equipment.
Salt-Away Concentrate, Mixing Unit, and Hose Spray Nozzle Required.
1. Remove 115ml cup from Mixing Unit and fill with Salt-Away. Be careful not to lose the O-ring. If you
have just flushed your salt water engine, no need to fill again with Salt-Away.
2. Replace cup. Always make sure O-ring is seated in the groove on top of the cup before replacing.
3. Connect garden hose to Salt-Away Mixing Unit. Mixing Unit is in 'Off' position.
4. Attach garden spray nozzle onto other end of Mixing Unit.
5. Turn on water. (Mixing Unit has been tested to withstand water pressure up to 60psi. Higher pressure may cause unit to malfunction.)
6. Turn Mixing Unit to 'Soap' (On) position.
7. Gently spray or mist Salt-Away onto your boat, jetski, trailer, towing vehicle and other equipment. Salt-Away removes
the salt, not heavy water pressure. There is no need to scrub.
8. Turn Mixing Unit to the 'rinse' position. Rinse off equipment. For excellent corrosion control, re-apply to
trailer and exposed metal surfaces and do not rinse off.
If procedures are followed as described above, a 115ml application will flush an engine and wash off a boat and trailer up to
10 metres in length.
Tip: Using quick-disconnect devices are convenient for Mixing Unit connections.
|
|
|
|
